We will exhibit at INCHEM TOKYO 2015, the 30th Plant Show!

Crushing between particles is promoted, increasing crushing efficiency and processing capacity! Contributes to reduced power consumption and improved performance!

The "Geopass GR" is a crusher that can mass-produce particles with a large crushing ratio of 5mm or less. By using rolls with 5 to 10 times the pressing force of conventional machines, the density during crushing is improved. This promotes the crushing of particles against each other, enhancing both crushing efficiency and processing capacity. It serves as an alternative to high-power crushers and mills, contributing to power reduction and performance improvement. 【Features】 ■ Promotes inter-particle crushing for high-density results ■ Higher crushing ratio and efficiency compared to impact crushers ■ Effectively crushes high-moisture raw materials ■ Low noise and low dust due to ultra-low roll rotation speed ■ Easy maintenance with segment rolls *For more details, please download the catalog or contact us.

• Crusher

To customers considering the introduction of vehicle detection sensors for parking lot construction, design, and management: Are you facing any issues with the challenges you currently have or selecting the right sensors for parking lot management? Hotron offers free materials that explain how to utilize vehicle detection sensors and the benefits of their introduction! ▽ Here is the lineup of materials ◉ Basic Guide to Vehicle Detection Sensors This guide focuses on the challenges and solutions in parking lot operations, introducing the overview of vehicle detection sensors. ◉ Key Points for Introducing Vehicle Detection Sensors This material discusses the benefits of introduction based on installation locations and specific challenges. ◉ Case Studies of Vehicle Detection Sensor Implementation This document introduces the challenges before implementation and the results after introduction. For more details, please download from our website and check it out. https://www.hotron.co.jp/download/

● This is a leak testing device for small electronic components that does not use fluorinated inert liquids (PFAS-free). ● There is no longer a need for unstable visual confirmation through liquid immersion testing. It adopts a quantitative testing method that allows for stable pressure leak testing. ● It is a tabletop leak testing device specifically for gross leaks, with accuracy equal to or greater than that of liquid immersion testing. ● The detectable range is approximately 1×10⁻² Pa·m³/s to 1×10⁻⁶ Pa·m³/s (varies depending on the target product). ● It is suitable for sealed structures ranging from a few millimeters to a maximum of 80 × 70 mm. Please feel free to contact us for more information!

The "Mechanical Stitching Method" by Nichinichisui Road Machinery Co., Ltd. is a new technique that allows for the repair of metal cracks without the application of heat. By using special bolts and reinforcement plates, cracks are physically removed, and repairs are made without causing any thermal impact to the base material. Repairs can be carried out in environments where open flames cannot be used. Since no heat is applied, the disassembly of equipment is minimized. ◎ For more details, please contact us. ◎ If a detailed technical explanation is needed, please contact us.

The "Mechanical Stitching Method" by Nichinichisui Road Machinery Co., Ltd. is a new technique that allows for the repair of metal cracks without the application of heat. By using special bolts and reinforcement plates, cracks are physically removed, and repairs are made without causing any thermal impact on the base material. Repairs can be carried out even in environments where open flames cannot be used. Since no heat is applied, the disassembly of equipment is minimized. ◎ For more details, please contact us. ◎ If a detailed technical explanation is needed, please contact us.

The "Mechanical Stitching Method" by Nichinichisui Road Machinery Co., Ltd. is a new technique that allows for the repair of metal cracks without the application of heat. By using special bolts and reinforcement plates, cracks are physically removed, and repairs are made without causing any thermal impact on the base material. Repairs can be carried out in environments where open flames cannot be used. Since no heat is applied, the disassembly of equipment is minimized. ◎ For more details, please contact us. ◎ If a detailed technical explanation is needed, please contact us.