A page for non-silicone type separators, SP type, has been created.

【New Development】This type contains no silicone at all, yet achieves a light release of 250 mN/25 mm. It is also gaining attention as an alternative to fluorosilicone.

A new acrylic type has been added to the IM Release Film (R) (non-silicone type). With a silicone-free formulation achieving a peel strength of 250 mN/25 mm, there are increasing opportunities to consider it as an alternative to fluorosilicone, and it has received positive feedback from many users due to its high performance and cost-effectiveness. This release film (separator) can be used for bonding with silicone adhesives and for electronic material carrier films that dislike silicone.

• EMC countermeasure products
• Printed Circuit Board
• plastic

We would like to introduce the '96 WJacket Tubes 0.5ml Type' handled by FCR and Bio Co., Ltd. This product is a tube with a 2D code that is autoclavable and compatible with DMSO and liquid nitrogen vapor. We also offer a TPE integrated screw cap (Internal type) available in six colors, so please feel free to contact us if you have any requests. 【Features】 ■ Polypropylene ■ Autoclavable ■ DMSO compatible ■ Compatible with liquid nitrogen vapor ■ Capacity: 0.5ml *For more details, please download the PDF or feel free to contact us.

The low-voltage fuse "SBFC-ET" is a slow blow fuse that can withstand temporary overcurrents and only blows under continuous overcurrents. It is particularly effective for devices in automobiles where the current temporarily increases significantly. It is suitable for fuel pumps, washer pumps, and similar applications. This low-voltage fuse is recommended for those facing circuit protection challenges in the automotive industry, construction machinery industry, and for low-voltage fuses (below DC70V).

The "Mechanical Stitching Method" by Nichinichisui Road Machinery Co., Ltd. is a new technique that allows for the repair of metal cracks without the application of heat. By using special bolts and reinforcement plates, cracks are physically removed, and repairs are made without affecting the base material with heat. Repairs can be carried out in environments where open flames cannot be used. Since no heat is applied, the disassembly of equipment is minimized. ◎ For more details, please contact us. ◎ If a detailed technical explanation is needed, please contact us.

Fukuda's new flagship model. - Masterless type (FLA-0200 series) - General type (FLA-0201 series) Two models of air leak testers. With the mastering correction function, high-precision measurements can be achieved in a short time. Please take a look at the catalog.

● This is a leak testing device for small electronic components that does not use fluorinated inert liquids (PFAS-free). ● There is no longer a need for unstable visual confirmation through liquid immersion testing. It adopts a quantitative testing method that allows for stable pressure leak testing. ● It is a tabletop leak testing device specifically for gross leaks, with accuracy equal to or greater than that of liquid immersion testing. ● The detectable range is approximately 1×10⁻² Pa·m³/s to 1×10⁻⁶ Pa·m³/s (varies depending on the target product). ● It is suitable for sealed structures ranging from a few millimeters to a maximum of 80 × 70 mm. Please feel free to contact us for more information!