0295 Bridge Measures for PEO (Polyethylene Oxide)

Introducing a case study of Brodisk, adopted by a chemical manufacturer.

This is an introduction to a case where the problems of a chemical manufacturer were solved by the introduction of "Brodisk." The material in question is polyethylene oxide. The particle size is quite coarse, but the flowability is not good at all, and it solidifies when squeezed by hand. The hopper size is approximately 1600mm in diameter, and by installing four standard-type "Brodisk" units in two tiers, the bridging phenomenon was eliminated. 【Overview】 ■Material - Particle size: 50μm to 1000μm - Specific gravity: 0.4 ■Hopper - Diameter: 1600mm - Discharge: 150A 【Key Points of This Equipment】 ■The elastic disk (silicone) is very important in terms of the risk of foreign matter contamination, as well as strength and durability. The silicone disks of this equipment are exceptionally strong and durable. Once you use it, you will understand! ■Control (how to aerate?) is crucial! We provide guidance on what should be done. We also have a dedicated controller available. *We have published numerous implementation examples on our website. You can check them out via the link below.

Other powder equipment