スガツネ工業 Product Lineup

● Since welding is not required and installation time can be significantly reduced, cost savings can be achieved. ● It is possible to join two or more adjacent panels. ● By using a special tool, the panels can be removed from the outside.

● No screws, nuts, or washers are required due to the snap-in design. Please refer to the DST series introduction for details. ● Since welding is not necessary, installation time can be significantly reduced, leading to cost savings. ● It is possible to connect two adjacent panels or three or more panels. ● A new compatible total plate thickness type of 4.2 to 6.2 has been added.

● No screws, nuts, or washers are needed due to the snap-in design. Please refer to the DST series introduction for details. ● Since welding is not required, installation time is significantly reduced, leading to cost savings. ● Two adjacent panels can be joined together.

●This is a catch that does not require a receiving seat, as it only requires hole processing on the receiving (door) side. ●By making the hole dimensions in the product's short direction 10mm or more, the catch position can be adjusted.

● Achieves one-touch installation with sufficient strength. No screws or welding are required. For details, please refer to the DST series introduction. ● Just by installing it, the earth clip scrapes the paint off the mounting surface, allowing the joined panels and fasteners to conduct electricity, functioning as grounding between the panels. ● Can connect two or more adjacent panels.