マスキシステム Product Lineup

You can use it without the need for procedures for obtaining licenses or permits that have already been acquired for specific low-power wireless devices. The receiver has a built-in relay and can handle currents up to 2A. If more is needed, it can drive external relays or similar devices. By installing a repeater, it is possible to extend the range from 200m to 2km depending on the conditions. Installation is easy, but we also accept OEM for embedded use.

• High frequency/microwave parts
• switch
• Other office supplies

In the past, there were many damages to crops caused by animals, but recently, there have been reports of significant damage to high-priced fruits during the harvest season for farmers. Additionally, there have been numerous reports of copper wire theft at solar power plants, which has been distressing. 【Function】 It constantly monitors the status of the sensors and alerts to any changes. Communication is updated every three seconds, and the receiving LED blinks each time, allowing confirmation that the signal is being received. When an anomaly occurs, a buzzer sounds immediately, and the LED for the anomaly channel lights up. If the system is damaged and the signal is interrupted, the buzzer will sound after about one minute. 【Sensor】 Wide-range sensor: Thin enamel wire or Teflon wire is laid out in appropriate places. It reacts when a person or animal cuts this wire. It can be stretched up to 500 meters without issue. Infrared temperature sensor Ultrasonic reflection sensor Wireless reflection sensor Simple switch Please install and use sensors that match the above locations and detection methods.

• others
• Other consumables
• Distance measuring device

One snow sensor can operate multiple groundwater pumping pumps to reduce costs. The installed receiver has an automatic relay function, allowing for layouts that exceed the single reach distance. I believe it can be applied in various other ways, so please feel free to contact us.

• Prototype Services
• Circuit board design and manufacturing
• Water treatment equipment

This is a long-distance switch remote control using a specific low-power 920MHz frequency. It operates at distances of approximately 100 to 400 meters in line of sight. Since it is a remote operation for areas that are not visible, confirmation of operation is obtained through two-way communication, and the operational status of the device is displayed on the remote control with an LED. Customization is also possible to match the devices being operated. We are looking for OEM partners.

• Other process controls
• Circuit board design and manufacturing
• Prototype Services

This is a telemetry system that supports both analog and digital using specific low-power frequencies of 920 MHz and 426 MHz. It enables two-way communication, allowing for not only information collection but also remote control and status confirmation. Customization is available to suit various applications.

• Remote Control
• Circuit board design and manufacturing
• Electrical Instruments/Electrometers