Would you like to review and improve your equipment? Industrial electric heaters.

【Test Cases】 1. Glass Fiber Organic Residue Test In the production of glass fibers, it is essential to burn off the organic materials in a drying oven. However, there was interest in whether it could be effectively burned off using our hot air generation equipment. After several discussions, an opportunity arose for a company visit, during which we operated the equipment as part of a factory tour and conducted a simple pattern test. If you contact us in advance, it is possible to check the availability of the equipment and conduct a simple test. 2. Surface Temperature Comparison Test Under High-Temperature Atmosphere In the equipment used by the customer, there is a risk of electric leakage when the surface temperature of the heater becomes high. Therefore, the specifications were changed to enhance the heat dissipation effect, and both old and new heaters were tested under the same conditions to measure and compare their surface temperatures. The results showed that by enhancing the heat dissipation effect, there was a tendency for the surface temperature of the heater to decrease. This time, due to temperature differences depending on the measurement method, it is necessary to consider a new challenge regarding the measurement method for actual furnace measurements, and we are currently working on it.

【Test Cases】 1. Glass Fiber Organic Residue Test In the production of glass fibers, it is essential to burn off the organic materials in a drying oven. However, there was interest in whether it could be effectively burned off using our hot air generation equipment. After several discussions, an opportunity arose for a company visit, during which we operated the equipment as part of a factory tour and conducted a simple pattern test. If you contact us in advance, it is possible to check the availability of the equipment and conduct a simple test. 2. Surface Temperature Comparison Test Under High-Temperature Conditions In the equipment used by the customer, there is a risk of electric leakage when the surface temperature of the heater becomes high. Therefore, the specifications were changed to enhance the heat dissipation effect, and tests were conducted on both old and new heaters under the same conditions to measure and compare the surface temperatures. The results showed that by enhancing the heat dissipation effect, there was a tendency for the surface temperature of the heater to decrease. This time, due to temperature differences depending on the measurement method, it is necessary to consider a new challenge regarding the measurement method in relation to actual furnace measurements, and we are currently working on it.

As a manufacturer of industrial electric heaters, we would like to introduce some improvement proposals that we can assist with. 【Issues】 "I want to prevent heat loss from the second and third layers of insulation." "I want to achieve energy-saving operation by preventing heat loss." "I want to make the furnace shell space more compact." 【Solutions】 Change the insulation material used as a backup for the heater. Use high-performance insulation material for the second layer. 【Results】 By adopting high-performance insulation material, a reduction in the amount of heat dissipated from the furnace is expected. *With the same thickness setting as calcium silicate board t5mm, the radiative heat amount is reduced by approximately 50%. ~According to board manufacturer catalog values~

As a manufacturer of industrial electric heaters, we would like to introduce some improvement proposals that we can assist with. 【Challenges】 "I want to increase capacity in the same area." "I want to eliminate temperature unevenness (improve heat uniformity)." "I want to increase the heating speed." 【Solution】 Change the heater using round wire coil heating elements to a heater using strip heating elements. 【Results】 ■ By covering the entire area of the insulation material with heating elements, uniform heat treatment can be achieved. ■ Compared to heaters using round wire coil heating elements, it is possible to input more than twice the wattage. We have received feedback from customers stating, "The radiation efficiency has improved," and "Installation was easy, just changing the fitting."