List of Inspection Equipment and Devices products

Achieves high collection efficiency through electrostatic methods. Offers a wide range of products from large to small sizes. Also compatible with water-soluble oil mist.

• air conditioning

Make contact by bringing one side of the plunger into contact with the electrodes or relay pins of the relay board! L=20mm to 1.5mm, φ1mm to φ0.1mm.

• probe
• Other electronic parts
• Inspection fixture

- X-ray generator with a maximum voltage of 300kV can capture images of carbon steel approximately 50mm thick. - Detection range: 325mm × 264mm.

• Other inspection equipment and devices

Inspection possible with high-vision, high-resolution, high-contrast three-dimensional perspective images.

• Other inspection equipment and devices

Laser hardening using temperature monitoring and feedback control of laser output.

• Other inspection equipment and devices

Welding of copper using high-power green laser.

• Other inspection equipment and devices

It is possible to visualize laser beams non-contact and to measure them continuously.

• Other inspection equipment and devices

By bringing the tip of the contact probe closer to the outside, the gap between the two points can be minimized without changing the thickness of the pin. Pin pitch between 0.4mm and...

• probe

In addition to marking and engraving as the original purpose of the marker, fine roughening processing on the work surface is also possible.

• Other inspection equipment and devices

We were able to significantly improve the performance of the probes even in high current measurements! It is also possible to increase the allowable current value, including the housing.

• probe

We also offer probes that use springs with a heat resistance of 300 degrees, one rank higher than SUS material!

• probe

Compared to conventional BeCu products, it is equivalent or even superior, so wear resistance is not a concern.

• probe

While seam tracking the unwelded line, the gap width is also measured simultaneously, and adaptive control is performed with optimal welding conditions based on the measured gap width.

• Other inspection equipment and devices

We undertake the design and development of equipment related to LCD inspections!

• Other inspection equipment and devices

An engineer will bring standard equipment to the specified location and carry out calibration work.

• Testing Equipment and Devices
• Analytical Equipment and Devices
• Other inspection equipment and devices